It is designed to eliminate housing and tube flex that can occur under harsh conditions. Team Z recently supplied us one of their trick 9-inch rear end housings that’s based upon Team Z’s standard Mustang Bolt-in Ford 9 housing but features the adjustable upper and lower control arm mounts found on their upgraded Outlaw Stock Suspension Bolt-in 9 housing. reinforced A-arms, and Koni dampers -Ford 9 inch rear axle with a fabricated housing, 3. For vehicles that will see very hard launches, there is an option to weld a back brace along the rear of the housing. Team Z Mustang LS Motor and Mid Plate Kit Our Price: 320. The fixturing and welding of the housing ends is always our last operation. This configuration is the safest way to maintain the proper alignment of the housing ends. While larger tubing is stronger, your mounts selection may have determined tube diameter. 250” wall 3” or 3 1/4” mild steel tubing, and choice of mounts and housing ends. The housing is fitted with fill and drain plugs, tubed with your choice of. The housing is designed to provide the clearance necessary for cases with heavy duty main caps and also allowing the use of 9”, 9 1/2”, or 10” gear sets The car is undergoing a swap to a Team Z Outlaw Stock Suspension 9-inch setup for better gear selection to the get the short times under 1.30 on a consistent basis. Secure welding of the tubes to the housing. Tube insertion locations are slotted for 5” to allow complete and Radial gusset plates brace end of housing tube and increase overall housing Housing tube support for more consistent and straighter launches. Ultra Fabricated housing centers are constructed from. Strange Engineering 9" Ultra Fab Housing for 1979-2004 Mustang
0 kommentar(er)
